Management port configuration (rj45), Hyperterminal, 3 management port configuration (rj45) – Datacom Systems VS-1200 User Manual
Page 27
Initial Configuration
27
© 2009 Datacom Systems Inc
4.3
MANAGEMENT Port Configuration (RJ45)
Once VS-1200 series connection is made to the
MANAGEMENT RJ45 port, open the terminal
emulation application and create a connection with settings that fit your needs:
The factory configured VS-1200 series IP Address, Subnet Mask and Default Gateway are as
follows:
IP Address: 192.168.1.1; Subnet Mask: 255.255.255.0; Default Gateway: 0.0.0.0
4.3.1
HyperTerminal
The following example utilizes Microsoft HyperTerminal. Any freely available terminal emulator may
be utilized, but please take note of the specific HyperTerminal setup settings if an alternate terminal
emulator is used.
IMPORTANT: For Host Address, if initial IP Address
HAS NOT BEEN
configured, use
192.168.1.1
(default) or
if initial IP Address
HAS BEEN
configured, use the
Local Area Network address input
during initial IP Address configuration.
HyperTerminal (terminal emulator) enter:
TCP/IP (Winsock)
Host Address: nnn.nnn.nnn.nnn [i.e., 192.168.1.1 or Local Area Network]
Port Number: 23
Set HyperTerminal (terminal emulator) properties
Under File>Properties>Settings
Emulation:
VT100
Under File>Properties>Settings>ASCII Setup
Check box:
Send line ends with line feeds
Check box:
Echo typed characters locally
After completing review of the
Command Line Interface (CLI)
section and
Exercise - CLI setting
Ports
section, detailed IP Address configuration can be found in the
IP Address Configuration
section.
17
36
28