Exercise - cli setting ports, 5 exercise - cli setting ports – Datacom Systems VS-1200 User Manual
Page 36
VS-1200 Data Acccess Switch
36
© 2009 Datacom Systems Inc
Step 13. If the pending IP Address is not correct, repeat Step 9, if the pending IP Subnet is not
correct, repeat
Step 10 and if the pending IP Default Gateway is not correct, repeat Step 11.
Repeat
Step 12 to review and verify that the pending IP Address, IP Subnet and IP Default
Gateway match the intended Local Area Network input IP Address, IP Subnet and IP Default
Gateway.
Step 14. Type Exit and press the Enter key to save the network address changes which ends the
connection session as indicated in a few seconds by .the Windows informational message balloon
pop-up icon "Local Area Connection - A network cable is unplugged."
Step 15. Close TELNET
Step 16. Disconnect the DRL512-2M-R serial cable.
Step 17. Install the VS-1200
series in your chosen network location.
4.5
Exercise - CLI Setting Ports
PREMISE: The configurable VERSAstream allows multiple network devices/tools to receive the
combined data of multiple Ethernet network segments. All VERSAstream 1200 Series’ Any-to-
Any ports can be set to be inputs or outputs as shown in the '
Command Line Interface (CLI)
'
section.
17