Datacom Systems VS-1200 - Manual (Page 30)

VS-1200 Data Acccess Switch 30
© 2009 Datacom Systems Inc
Step 5. On the Connect to window, create a serial link by selecting the COM port assigned to the
serial port on your PC from the
Connect using: pull-down menu and select OK
Step 6. Next, configure the COM Properties. The initial correct settings to communicate with the
VS-1200 series (9600, 8, None, 1, None) are shown below. Once all settings are configured
correctly, click
Apply, then click OK.
Step 7. You are now connected, hit the Enter key twice in succession (i.e., Enter, Enter) to display
the
Enter Username: prompt. All Usernames and passwords are case-sensitive. Type
Administrator (default value) and press the Enter key. At the Enter Password: prompt, type admin
(default value) and press the
Enter key to display the command line > prompt. At the command line
> prompt, type su and press the Enter key. At the Enter Password: prompt, type password
(default value) and press the
Enter key to display the command line # prompt. To see a list of
available commands, at either the > or # command line prompt, type ? and press the Enter key.