Datacom Systems VS-1200 - Manual (Page 35)

Initial Configuration 35
© 2009 Datacom Systems Inc
Step 8. You are now connected at the Enter Username: prompt. Usernames and passwords are
case-sensitive. Type
Administrator (default value) and press the Enter key. At the Enter
Password: prompt, type admin (default value) and press the Enter key to display the command
line
> prompt. At the command line > prompt, type su and press the Enter key. At the Enter
Password: prompt, type password (default value) and press the Enter key to display the command
line
# prompt. To see a list of available commands, at either the > or # command line prompt, type ?
and press the Enter key .
Step 9. SET IP (SE IP) by typing se ip xxx.xxx.xxx.xxx corresponding to a valid IP address for
your network. Press the
Enter key to continue.
Step 10. SET SUBNET (SE SU) by typing se su xxx.xxx.xxx.xxx corresponding to your
network's subnet mask. Press the
Enter key to continue.
Step 11. SET GATEWAY (SE GA) (if needed) by typing se ga xxx.xxx.xxx.xxx corresponding
to your network's default gateway. Press the
Enter key to continue.
Step 12. SHOW (SH) by typing sh and press the Enter key to display and affirm that the pending
IP Address, IP Subnet and IP Default Gateway match the intended Local Area Network input IP
Address, IP Subnet and IP Default Gateway.