ADLINK USB-1903 - Manual (Page 45)

Installing the USB-1900 Series Module 31
USB-1900 Series
3 Installing the USB-1900 Series Module
3.1 Connecting the USB-1900 Series Module
1. Turn on your computer.
2. Connect the USB-1900 Series module to one USB 2.0
port on your computer using the included USB cable.
3. The first time the USB-1900 Series module is connected,
a New Hardware message appears. It will take around 6
seconds to load the firmware. When loading is complete,
the LED indicator on the rear of the USB DAQ module
changes from amber to green and the New Hardware
message closes.
4. The USB-1900 Series module can now be located in the
hardware Device Manager, as shown.
Figure 3-1: USB-1900 module in Windows Device Manager
WARNING:
The appropriate driver must be installed before you can con-
nect the USB DAQ to your computer system. Refer to
Section 1.7: Driver Support for Windows for driver support
information.