ADLINK PCI-7260 - Manual (Page 26)

16 Register Format
3.1 I/O Address Map
The 7260 registers are all 16-bit wide. Users can access these
registers only by 16 bits I/O instructions. The control of the relays
and status of the isolation input is by means of accessing regis-
ters. The following table shows the register map, including
descriptions and their offset addresses relative to the base
address.
Table 3-1: PCI-7260 Register Map
Offset Write Read
0x00h Relay Output CH. 0~7 Relay Output Read back CH.0~7
0x02h WDTimer Load Config
Emergency Shut Down Dip
Switch State
0x04h
Emergency Shut Down Setup
Register (EMG_SHDN)
Isolated Input CH. 0~7
0x06h COS Setup Register COS Latch Register
0x08h
Interrupt / WDT Control
Register
Interrupt / EMG_SHDN / WDT
Status Register
0x0Ah --- Initial Dip Switch State