ADLINK PXIS-2508 - Manual (Page 54)

44 Appendix
A.3 Basic Troubleshooting
Problem What to Do
System fails to power up X Check if the power cord is properly
plugged into the chassis power con-
nector and wall socket/power strip.
X Check if the wall socket/power strip
is live.
X Check if the main power switch at
the back of the chassis is turned on.
X Make sure the standby power button
at the chassis front panel is turned
on.
There is no LCD display
(PXIS-2558T only) X Make sure the system is turned on.
X Connect an external display to the
system controller’s VGA port, then
check if there is video output.
X If video output is present on the
external display, adjust your display
settings and enable LCD video.
X If video output is not present on the
external display, check if the system
controller is properly installed.
X If there is no video output even when
the system controller is properly
installed, contact ADLINK for further
assistance.
There is no video output
in the external display X Redirect the video output to the inte-
grated LCD (PXIS-2558T only).
X Check if your external display is
functioning.
X Check your display settings and
make sure you enable external
video.