ADLINK PXIS-2690P - Manual (Page 20)

12 Installation
3.1 Removing the Module Cover
The PXIS-2690P comes with a module cover that protects wirings
and connections to the system controller and peripheral modules.
You must remove the module cover before installing the system
controller and/or peripheral modules.
To remove the module cover:
1. Locate two screws on both sides of the cover, then
loosen them until the cover disengages from the chassis.
2. Pull the rear edge of the cover up to a 45º angle, then lift.
3. Set the module cover aside.