ADLINK PXIS-2690P - Manual (Page 35)

Troubleshooting and Maintenance 27
4 Troubleshooting and Maintenance
4.1 Installation Problems
Failure to start the system usually results from incorrect installa-
tion of the system controller, peripheral modules, etc. Go through
the following checklist before you start up the system.
X The system controller is properly installed and secured.
X All peripheral modules are properly seated on the slots.
X All cables are properly connected to the system controller/
peripheral modules.
X All peripheral modules installed are compatible for use in
the chassis.
X The power cord is properly plugged into the chassis power
connector and power outlet/wall socket/power strip.
If the system fails to turn on even after all installation conditions
are met, remove all peripheral modules that you installed, then try
again. If the system turns on properly, try installing one peripheral
module at a time, then test if the system will power-up. You may
also try installing the modules into different slots until you get the
desired result.
4.2 BIOS Beeps
BIOS beeps indicate errors in system initialization. These beeps
are usually associated with video and memory errors. If the sys-
tem beeps during start up, check if the display is properly con-
nected to the system controller or if the integrated LCD drivers are
properly installed. You may also check if the memory modules are
properly installed in the system controller.