ADLINK PCI-7856 - Manual (Page 29)

Motionnet Master-Slave Motion System 17
PCI-7856
User’s Manual
3.2 MNET Motion Modules
MNET motion slave module is a wire-saving solution. ADLINK
offers three specific types of modules for connecting to Mitsubishi
J3 servos, Panasonic A4 servos and Yaskawa Sigma II, III and V
servos. Each module is easy and convenient to plug into the servo
drivers. All of the servos can be connected serially through the
recommended cable, greatly reducing wiring requirements.
Not only are specific single axis control modules supported, but
also 4-axes control modules namely “MNET-4XMO” and “MNET-
4XMO-C”. Both offer the fundamental motion functions such as
point-to-point, zero-position searching, programmable accelera-
tion/ deceleration, T/S curve speed profile and so on. Besides the
MNET-4XMO-C supports high-speed position comparison, trigger
output function and point table for continuous contouring applica-
tion, please refer to the user guide of MNET-4XMO for more
details.
Series Model Servo Driver Axis No. Mechanical I/O
MNET Single Axis
Motion Modules
MNET- MIA Panasonic A4 1 PEL, MEL, ORG, SD, EMG
MNET- J3 Mitsubishi MR-J3 1 PEL, MEL, ORG, SD, EMG
MNET- S23 Yaskawa Sigma II, III 1 PEL, MEL, ORG, SD, EMG
MNET 4-axes
Motion Modules
MNET-4XMO General Purposed 4 PEL, MEL, ORG, SD, EMG
MNET-4XMO-C General Purposed 4 PEL, MEL, ORG, SD, EMG, TRG
Table 3-2: MNET Motion Module Series