Dish Network DVR-7000 - Manual (Page 16)

Section 3 Installation
Page 3 - 6 EchoStar DVR-7000 Viaccess
©
2
002
E
c
hoS
tar
Inte
rnati
o
nal
C
o
rp
orat
io
n
A
ll
rig
hts
re
s
erved
F OR MOTORIZED INSTALLATIONS - A UTOSAT
32. Wait for the search to complete:
a. the receiver display shows a moving dot;
b. the search completed popup menu appears.
33. On the RCU, press the OK key. to end the initial
setup procedure.
CAUTION
On the motorized dish, set the physical East and West limit switches first. Failing to
do so might cause damage to your motorized dish installation or other properties.
22. Make the required selections.
23. Read the available help text for information.
Note that only the white fields are selectable,
other fields show reference information.
24. Go to the Autosat field.
25. On the RCU, press the OK key to advance.
26. On the RCU:
a. press thekey to set the East limit;
b. at the motor error, press thekey once;
c. press the OK key.
27. On the RCU, press the OK key.
28. Select a Eastern satellite which you can receive.
29. When in the location field:
a. press and hold thekey and watch the signal
indicator for an indication;
b. in the signal indicator, make sure a network
name is shown;
c. press thekey to select another transponder
for signal verification;
d. use thekey to fine tune for the best signal
level and quality;
e. press thekey to select the location bar;
f. press the OK key, note that the saved position
of the satellite is shown.
30. Repeat the procedure for the middle and
Western Satellite.
31. Set the West limit (key), refer to step 26.
32. Go to the Autosat field.
33. On the RCU, press the OK key to advance.