Dish Network DVR-7000 - Manual (Page 62)

Section 6 Maintenance
Page 6 - 2 EchoStar DVR-7000 Viaccess
©
2
002
E
c
hoS
tar
Inte
rnati
o
nal
C
o
rp
orat
io
n
A
ll
rig
hts
re
s
erved
2.2. TO CHANGE THE USER LNB SETTINGS
2.3. ABOUT ECHOSTAR - RECEIVER INFORMATION
6. Wait for the Check Signal page to appear.
7. In the Check Signal menu make the required
selections for transponder and search mode.
8. Read the available help text for information.
9. If the red dot in the transponder field stays:
a. select another transponder;
b. go to the check signal field;
c. on the RCU, press the OK key.
10. Go to the Search Channels field.
11. On the RCU, press the OK key.
12. Wait for the search to complete:
a. the receiver display shows a moving dot;
b. the search completed popup menu appears.
13. On the RCU, press the OK key.
.
1. On the RCU, press:
a. the MENU key;
b. the  key to select the menu;
c. the OK key, to select the menu.
2. Press the OK key and make the selections.
3. Read the available help text for information.
4. Go to the Store Settings field.
5. On the RCU:
a. press the OK key to save the settings;
b. press the EXIT key to leave the menu.
1. On the RCU, press:
a. the MENU key;
b. the  key to select the menu;
c. the OK key, to select the menu.
2. In the About EchoStar information menu you can
look up the factory and receiver information.
3. Read the available help text for information.