Dish Network DVR-7000 User Manual
Page 73
Section 7
Digital Satellite Receiver
Page 7 - 5
©
2
002
E
c
hoS
tar
Inte
rnati
o
nal
C
o
rp
orat
io
n
A
ll
ri
g
hts
re
s
erved
7
5. In a motorized
installation, I cannot
select a specific satellite.
■
The required satellite is
located outside the
selected East or West
limit.
■
If physically possible,
mind dish damage, revise
the limit setting.
■
Select another satellite.
6. In a motorized
installation, the positioner
reacts unpredictable
which results in incorrect
positioning of the dish.
■
The cables used are
worn, damaged or
corroded.
■
Inspect the cable for
possible damage and
install new cable as
required.
■
The cable is incorrectly
finished or not sufficiently
shielded.
■
Use sufficiently shielded
and correctly finished
cables.
7. During (initial) setup of
the receiver, no channels
are found.
■
You did not select the
correct LNB(F).
■
On the receiver, in the
installation setup menu
select the correct LNB(F).
■
When installed, you have
selected the incorrect
switch type or port.
■
On the receiver, in the
installation setup menu
make the correct
selections.
■
You have selected the
incorrect satellite to
search channels on.
■
On the receiver, in the
installation setup menu
select the correct
satellite.
■
You have selected the
incorrect search method.
■
At an initial setup, always
choose the option All.
8. The signal indicator
shows one indicator
(only signal strength).
■
You have selected an
analog transponder
■
Select another (digital)
transponder.
Problem
Possible cause
What to do?