Dish Network DVR-7000 - Manual (Page 71)

Troubleshooting Section 7
Digital Satellite Receiver Page 7 - 3
©
2
002
E
c
hoS
tar
Inte
rnati
o
nal
C
o
rp
orat
io
n
A
ll
ri
g
hts
re
s
erved
7
4. REMOTE CONTROL UNIT (RCU) RELATED
5. DVR RELATED
Problem Possible cause What to do?
1. Receiver does not
respond to the RCU.
■ Batteries are empty. ■ Insert new batteries.
■ The RCU is set to another
mode (TV, VCR, AUX). ■ On the RCU, press the
SAT key.
■ The receiver code is not
programmed correctly. ■ Program the SAT mode
with code 0222, see the
appendix for instructions.
2. Receiver does some-
times not respond to the
RCU.
■ Direct sun light from
behind the receiver. ■ Close the sun blinds or
get closer to the receiver.
■ You do not aim
sufficiently at the receiver. ■ Aim at the receiver
display.
■ install a RCU extender.
■ Batteries are almost
empty. ■ Insert new batteries.
Problem Possible cause What to do?
1. I can not record a TV or
radio broadcast onto the
hard disk drive.
■ You have pressed the
record key once. ■ Press the record key
twice, EchoStar has build
in a safety to prevent
unwanted recording.
■ You have selected an
analog station. ■ Analog broadcasts
cannot be recorded onto
the digital DVR, Please
record the broadcast with
a VCR.
2. The programmed channel
is not recorded com-
pletely.
■ Local time setting is not
correctly set. ■ Check the Local Time
setting and reset as
necessary.
■ The EPG data does not
reflect the actual start or
stop time. ■ This data is supplied by
the service provider and
beyond control. You can
set the timer 5 minutes
earlier/later than shown.
3. Live pause seems not to
work.
■ You have selected an
analog station. ■ Live pause records the
program temporarily onto
DVR. Analog broadcasts
cannot be recorded onto
the digital DVR.
■ You have pressed the
record key. ■ Press the pause key
once.
4. I cannot access the spe-
cial functions menu.
■ The InfoBanner is not in
view. ■ Use the i-key to show the
InfoBanner and press the
MENU key.
■ You did not press the
MENU key. ■ Press the MENU key.