Eurocom M590KE EMPEROR-X - Manual (Page 42)

36 - RAID Configuration
Concise User’s Guide
English
25. Insert the RAID Driver Diskette into the external USB Floppy drive and press Enter.
26. Select “NVIDIA RAID CLASS DRIVER (required)” and press Enter to select it.
Figure 18 - RAID Driver Select 1
27. The system will now read from the floppy disk drive and then return to the Windows Setup menu.
28. When the Windows Setup menu appears, press the <S> key a second time to "Specify Additional Device".
29. Press Enter, and use the arrow keys to select the “NVIDIA nForce Storage Controller (required)” and press Enter again.
Figure 19 - RAID Driver Select 2
30. Press Enter to continue installing the operating system (the screen should show both drivers as per Figure 20 below) as
normal (see your Windows documentation if you need help on installing the Windows OS).
Figure 20 - Windows Setup Both Drivers Selected
31. Install the chipset driver as per the instructions in “Chipset” on page 25 .
NVIDIA RAID CLASS DRIVER (required)
NVIDIA nForce Storage Controller (required)
NVIDIA RAID CLASS DRIVER (required)
NVIDIA nForce Storage Controller (required)
Windows Setup
Setup will load support for the following mass storage device(s):
NVIDIA RAID CLASS DRIVER (required)
NVIDIA nForce Storage Controller (required)
M590KE Concise UG.book Page 36 Friday, October 13, 2006 1:25 PM