EXFO RTU 310-310G IP Services Test Head - Manual (Page 105)

Creating and Starting a Test Case
Ethernet and Fibre Channel Application 93
Ethernet RFC 2544 Test Case
5. Traffic stream configuration
5a. For IPv4, select the Automatic IP
Address check box to dynamically
obtain an IP address from a DHCP
(Dynamic Host Configuration Protocol)
server or set the source and destination
IP addresses, Subnet Mask, and the
Default Gateway. Refer to IPv4
Configuration on page 489 for more
information.
5b. For IPv6, set the destination IP address
and if required, click the IPv6 Config
button for additional IPv6 settings. Refer
to IPv6 Address Configuration on
page 491 for more information.
5c. If required, set the network source MAC
Address. Select the Resolve MAC
Address check box or set the
destination MAC address. Refer to MAC
on page 177 for more information.
5d. Select the Frame Format. Choices are
Ethernet II and 802.3 SNAP. Refer to Frame Format on page 177
for more information.
5e. Set the VLAN parameters when required. Refer to MAC on
page 177 for more information.
5f. Click Finish to complete the test setup. The RFC 2544’s Global
tab is automatically displayed.