EXFO RTU 310-310G IP Services Test Head - Manual (Page 396)

System Tabs
384 RTU-310/310G
Default/Ethernet Test Preferences
Default/Ethernet Test Preferences
Click Default/System and Preferences/Default Test Preferences/Eth. Test
Preferences.
For RTU-310
For RTU-310G
Allows setting the Ethernet default test parameters that will be applied
every time a test is created manually using Test Setup. Changes to the
default test preferences will only apply when a new test case is created.
Configuration

Laser On: Selects Laser On every time a test is created manually using
the wizard. The Laser On check box is selected by default.

Couple Start/Enable TX: Automatically selects the stream
transmission when the test is started. This setting applies to Frame
Analyzer test only. The stream transmission stops when the test is
stopped. The Couple Start/Enable TX check box is cleared by default.
Refer to Enable TX - On/Off button on page 164 for more information.