EXFO IQS-3150 Variable Attenuator for IQS-500/600 - Manual (Page 68)

Monitoring Variable Attenuator Modules
62 IQS-3150
Using QuickTools
Using QuickTools
With QuickTools, you can fine-tune your module directly, while keeping an
eye on your entire test setup.
Note: You can only access QuickTools if the module’s monitor window is selected
from the Monitors function tab and is currently active.
To start QuickTools:
1. From the Monitors function tab, elect the monitor window of the
module you wish to control.
2. Using the arrow button in the upper left corner, select QuickTools.
The corresponding monitor window flashes when QuickTools is
activated.
Note: If you want to open the actual application for your module rather than
QuickTools, click Show Controller.
Attenuation
control mode
Output Power
control mode
For more information on settings and
controls, refer to Control Center Settings
and Controls on page 29.