Glow-worm Clearly Heat Recovery - Manual (Page 5)

5
Important Information
Notes on the documentation
The following notes serve as a guide for the entire
documentation. Further documents apply in combination with
this installation instructions. We accept no liability for any
damage caused by non-observance of these instructions.
Documentation Storage
Give this installation manual and all accompanying
documents to the operator who will store them so that they
are available when required.
Manual Validity
This installation manual is exclusively for the appliances:
Atmosorb HRD 275 part number 0010008891
Atmosorb HRD 350 part number 0010008892
For the part number of your unit, refer to the data plate
positioned on the underside of the bottom panel.
Intended Use
The Atmosorb is a wall-mounted ventilation system with heat
recovery.
The unit is connected to an air ducting system, which is
equipped with silencers, pre-filters, fresh-air and exhaust-air
grilles and louvres.
Fresh air grilles supply fresh air to the living areas and stale
moist air is extracted from the kitchen, bathroom and WC.
An optional bypass is available for summer operation, it can
directly provide living rooms with cool external air whenever
it is necessary. The external air flow bypasses the heat
exchanger.
With the digital remote control the user is able to automatically
switch and adapt the units power to suit their own
requirements.
The unit ensures:
• A constant air exchange in the building.
• The hygienic minimum air exchange in accordance with UK
building regulations Part F.
• Energy savings thanks to high efficiency heat recovery.
• A high hygiene standard due to the prevention of humidity
and mould damages of the building.
Safety Instructions
The Atmosorb ventilation units are built and designed
according to accepted safety rules and regulations.
Nevertheless, there is still a risk of injury or death to the user
or others or of damage to the unit and other property in the
event of improper use or use for which it is not intended.
The unit must be installed by a competant person, who is
responsible for the observance of the current regulations,
rules and guidelines.
The remote control including the operating mode selector
and the timer must only be used for controlling the unit as
described in these instructions; it is not designed for any other
purpose.
Due to high level of dust, operation during any construction
phase is not allowed.
Any other or additional use is considered to be improper.
The unit is not suitable for ventilating swimming pools.
The manufacturer/supplier shall not be responsible for any
damages resulting from such improper use.
The user alone bears the risk.
Intended use includes the observance of the operating and
installation manual and all other applicable documents,
as well as adherence to the maintenance and inspection
conditions Installation of the device can be only carried out by
a competent person approved at the time by the Health and
Safety Executive and will be responsible for the changes in
the air flow adjustment.
This unit should only be used in conjunction with a propriety
ductwork system installed in accordance with HVCA guide
DW144 (steel ductwork) & DW154 (plastic ductwork).
The unit is equipped with a frost protecting sensor.
This sensor measures the temperature of the discharge
air. The fresh air fan is switched off if the discharge air
temperature falls below 3°C.
Once switched off, the fresh air fan is only switched on again
when the discharge air temperature has risen above 8 °C.
If the protection circuit is activated against the low pressure
(STOV, see section 5.1.1), the frost protection sensor switches
both ventilators off.
The outside air flow may be much cooler than the temperature
of the discharge air measured by the frost protection sensor
before the anti-freeze monitoring device is activated. Its
operation is possible up to -7 °C outside temperature.
Manufacturer’s Warranty and Liability
Glow-worm warrants that this product is free from defects of
manufacture.
It is covered by a manufacturer’s warranty of 24 months. The
aforesaid manufacturer’s warranty shall be applied in addition
to any legal warranty cover and shall not replace or restrict
your legal claims under the Sale of Goods Act. This warranty
shall become effective from the day of installation, or 2 years
after the manufacture of this system whichever is soonest.
This warranty shall be applicable only for such appliances
which have been installed in UK by a competent installer.
If on the rare occasion that material or fabrication defects
arise during the warranty period, the Glow-worm Customer
Service will repair these defects free of charge. It shall be at
the sole discretion of the manufacturer’s Customer Service
if he is to repair a defective unit or to replace it. Work under
warranty shall never cause an extension of the warranty
period.
This warranty shall only cover material or manufacturing
defects. The warranty shall not be applicable to such faults or
defects caused due to improper installation, commissioning,
handling and use, insufficient maintenance or intervention by
unauthorised persons. The warranty shall become void if such
work is executed to the appliance by other persons than those
belonging to our customer service or an authorised installer.
The aforesaid shall apply as well if parts or components are
incorporated in the unit or if the unit is connected to parts or
components which have not been approved and certified by
Glow-worm. Furthermore, the aforesaid warranty shall not be
applicable to such claims exceeding the elimination of defects
and faults free of charge, e.g. claims for damages.
Please call our service number 01773 596510 to report any
defects under warranty.
Service and Maintenance
To ensure regular servicing, it is strongly recommended
that arrangements are made for a Maintenance Agreement.
Please contact Glow-worm Aftersales Service (01773 596510)
for further details.
Spare Parts
Remember, when replacing a part on this appliance, use
only spare parts that you can be assured conform to the
safety and performance specification that we require. Do not
use reconditioned or copy parts that have not been clearly
authorised by Glow-worm.
If a part is required contact Glow-worm’s own service
organisation using the telephone number on the inside front
cover of this booklet.