Glow-worm Clearly Hybrid - Universal Module System - Manual (Page 29)

0020096317_01 - 02/11 - Glow-worm
- 27 -
9 Re-check and restart
• Once the system is installed, check the operation of each
appliance.
• Start the system to ensure that any adjustments operate correctly
and check that the appliances operate safely.
• Reset the fault reports for all appliances. To do this, refer to
the "Component info." section.
• Check the water-tightness of the appliances and eliminate any
leaks.
• Check the entire control and safety system, settings and
operation.
• Start the "Self check" procedure to test the system
connections.
10 User information
At the end of the installation, the installer must:
- explain the operation of the appliances and its safety devices
to the user, if necessary provide a demonstration and answer
any questions;
- hand over to the user all the required documentation, fi ll in the
documents where necessary;
- advise the user of the precautions necessary to prevent
damage to the system, appliances and the building;
- remind the user to service the appliances annually.
The user shall not interfere with or adjust sealed components.
Any servicing must be carried out by a competent person
approved at the time by the Health and Safety Executive.
INSTALLATION
EN