Glow-worm Envirosorb3 - Manual (Page 27)

Decommissioning 9
0020154078_03 Envirosorb₃ Installation instructions 27
9 Decommissioning
9.1 Temporary decommissioning
1. Switch the product off.
2. Disconnect the product from the power supply.
9.2 Permanently decommissioning
1. Switch the product off.
2. Disconnect the product from the power supply.
3. Drain the product. (→ Page 26)
4. Dispose of or recycle the product and its components.
10 Customer service
For contact details for our customer service department, you
can write to the address that is provided on the back page,
or you can visit www.glow-worm.co.uk.
11 Disposal
11.1 Recycling and disposal
▶ The competent person who installed your product is re-
sponsible for the disposal of the packaging.
If the product or any batteries that it contains are
marked with this symbol, they contain substances hazardous
to human health and to the environment.
▶ In this case, do not dispose of the product and any bat-
teries that it contains with your normal household waste.
▶ Instead, bring the product and any batteries to a collec-
tion centre for batteries and electrical or electronic appli-
ances.
11.2 Arranging disposal of coolant
Warning.
Risk of damage to the environment.
This heat pump contains R 410 A coolant.
The coolant must not be allowed to escape
into the atmosphere. R 410 A is a fluorinated
greenhouse gas covered by the Kyoto Pro-
tocol, with a GWP of 1725 (GWP = Global
Warming Potential).
▶ Before the product is disposed of, have
the coolant which it contains completely
drained into a suitable vessel so that it
can then be recycled or disposed of in
accordance with regulations.
The competent person who installed the heat pump must
dispose of the coolant.
Personnel who are approved for energy recovery must have
the relevant certification that corresponds to the valid regula-
tions.