Glow-worm Ultracom2 sxi - Manual (Page 6)

0020092785_02 - 05/10 - Glow-worm
- 4 -
2.2 Data label
The data label certifies the country where the appliance is
intended to be installed.
Data label location:
1
Key
1 Data label
The data label contains the following data:
- The name of the manufacturer
- The country of intended destination
- The commercial name of the appliance and its serial number
- The types of flues installations authorised
- The appliance's gas category
- The gas type, group and pressure, set in the factory
- The maximum pressure in the heating circuit (PMS)
- The NOx class of the appliance
- The type and voltage of electricity supply
- The maximum power rating
- The electrical protection class
- The minimum and maximum heat input (Q)
- The minimum and maximum power output (P)
- The CE number and logo
a The appliance shall only be connected to the gas
type(s) indicated on the data label.
2.3 Gas category
This boiler is for use only on G20, but can be converted for use
on G31 (except 12sxi).
• To adapt the appliance to another type of gas, see the
chapter "Gas conversion".
2.4 Regulation and statutory requirements
2.4.1 CE Mark
This boiler meets the requirements of Statutory Instrument,
No. 3083 The Boiler (Efficiency) Regulations, and therefore is
deemed to meet the requirements of Directive 92/42/EEC on
the efficiency requirements for new hot water boilers fired with
liquid or gaseous fuels.
Type test for purposes of Regulation 5 certified by: Notified
body 1312.
Product/production certified by: Notified body 0086.
The CE mark indicates that the appliances described in this
manual are in compliance with the following directives:
- European directive n°2009-142 relative to gas appliances
- European directive n°2004-108 from the European
Parliament and Council relative to electromagnetic
compatibility
- European directive n°2006-95 from the European Parliament
and Council relative to low voltage
- European directive n°92-42 relative to the yield of boilers
2.4.2 Local regulations
Benchmark places responsibilities on both manufacturers
and installers. The purpose is to ensure that customers are
provided with the correct equipment for their needs, that it is
installed, commissioned and serviced in accordance with the
manufacturer’s instructions by a competent person approved at
the time by the Health and Safety Executive and that it meets
the requirements of the appropriate Building Regulations.
The Benchmark Checklist can be used to demonstrate
compliance with Building Regulations and should be provided to
the customer for future reference.
Installers are required to carry out installation, commissioning
and servicing work in accordance with the Benchmark Code
of Practice which is available from the Heating and Hotwater
Industry Council who manage and promote the Scheme.
• Visit www.centralheating.co.uk for more information.
INTRODUCTION