Golden Blount SF 3624 TV - Manual (Page 22)

22
LPG (PROPANE) WARNING (CONT’D)
IMPORTANT: Always keep the appliance area clear and free from combustible materials,
gasoline and other flammable vapors and liquids.
Never obstruct the flow of combustion and ventilation air. Keep the front of the appliance
clear of all obstacles and materials.
To obtain proper operation, it is imperative that the pilot and main burner flame
characteristics are steady, not lifting or floating. Typically the top 1/4 Inch of the flame
sensor should be engulfed in the pilot flame. (Figure 10)
TROUBLE SHOOTING (STP-SPARK TO PILOT MODEL)
With proper installation and maintenance, your new Gas Fireplace should provide years
of trouble-free service. If you do experience a problem, refer to the trouble shooting
guide shown below. This guide will assist a qualified service person in the diagnosis of
problems and the corrective action to be taken.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
Ignitor will not spark or pilot
will not light 1. No gas supply or shutoff
valve is OFF
2. Air in gas line
3. Construction debris
clogging pilot orifice
4. Low gas pressure
5. Kinked pilot line
6. Control valve is not opening
7. No power to unit
or ignition module
8. Damper Closed
1. Check to see if you have
gas supply and that
equipment shutoff valve
is opened
2. Repeat lighting procedure
several times to purge all air
out of lines. If after repeated
attempts appliance does
not light, call for qualified
service and repair
3. Remove debris and dirt,
inspect and clean any other
possible obstructions
4. Contact your gas supplier to
check pressure
5. Have a qualified technician
replace pilot line
6. Replace control valve
7. Check that main power is on
and that all wire connections
are made correctly to
ignition model (see Wiring
Diagram, page 20). Check
battery voltage and replace
batteries if needed. If battery
voltage is good and module
does not operate, have
module replaced.
8. Open Damper