Labconco Purifier Filtered PCR Enclosures 3970425 - Manual (Page 12)

Product Service 1-800-522-7658 8
C
HAPTER
3
G
ETTING
S
TARTED
Now that the site for your Filtered PCR Enclosure is properly prepared, you are
ready to unpack, inspect, install, and validate your enclosure. Read this chapter to
learn how to:

Unpack and move the enclosure.

Set up the enclosure with the proper supporting structure and work surface.

Verify HEPA filters integrity.

Connect the electrical supply.

Set the downflow velocity with the speed control adjustment.

Validate enclosure airflow.

Seal the enclosure to the work surface.
Depending upon which model you are installing, you may need common
mechanical and electrical installation tools in addition to wrenches, ratchets,
sockets, a nut driver set, a flat-blade screwdriver, a Phillips screwdriver, and a
carpenter level to complete the instructions in the chapter.
Each enclosure model weighs between 125 to 195 lbs. each (55
to 85 kg). The shipping container allows for lifting with a
mechanical lift truck or floor jack. If you must lift the
enclosure manually, follow safe-lifting guidelines.
Do not lift
by the lower air foil .
!