Installing ceiling enclosures above the fume hood, Installing rear panels behind the fume hood, Installing additional service fixtures – Labconco Protector XStream Laboratory Fume Hoods 9840803 User Manual
Page 38
34
Product Service 1-800-522-7658
Chapter 7: Modifying Your Protector Fume Hood
Installing Ceiling Enclosures
above the Fume Hood
Your Protector XStream Fume Hood has mounting holes to accept
a ceiling enclosure to close off the area between the top of the
hood and the ceiling. Contact Labconco Customer Service for
ordering information.
Figure 7-2
Installing Rear Panels Behind the
Fume Hood
Your Protector XStream Fume Hood can be modified to add a rear
panel behind the fume hood when the fume hood is placed on an
island. Contact Labconco Customer Service for ordering
information.
Installing Additional Service
Fixtures
Additional service fixtures can be installed in the available service
fixture holes in both sidewalls and corner posts. The fume hood is
factory set to accept up to four valves per side. Contact Labconco
Customer Service for information.