Labconco FreeZone 4.5 Liter Freeze Dry Systems 77510 Series - Manual (Page 14)

Chapter 3: Getting Started
Product Service 1-800-522-7658 10
Plus the following:
Part # Component Description
7416600 User’s Manual
1291000 Plug (230V models only)
7373450 Vacuum Hose
1488800 Hose Clamps (2)
7730700 Chamber Lid
7688500 Lid Gasket
7445100 Freeze Dry Valve Wrench
If you did not receive one or more of the components listed for your Freeze Dryer,
or if any of the components are damaged, contact Labconco Corporation
immediately for further instructions.
Setting Up Your Freeze Dryer
After you verify receipt of the proper components, move your Freeze Dryer to the
location where you want to install it. Then, follow the steps listed below.
Component Orientation
The refrigeration system in the Freeze Dryer draws air in through one side of the
cabinet and exhausts air out through the other side. A minimum of 3" should be
allowed between the sides of the Freeze Dryer and the adjacent wall surface.
Restriction of the airflow through the cabinet during operation could adversely
affect performance.
After the console model is positioned at the location where it will be operated, it
should be securely attached to the floor. Use (2) 1/4" x 5.0 long wood screws or
lag bolts if the floor is wood or concrete anchors if the floor is concrete. Two .312
diameter holes are located in the floor of the lower cabinet. Using these holes as a
template, mark the floor directly under the two holes. Roll the console Freeze
Dryer aside and drill suitable pilot holes for the selected screws/anchors. Install the
vacuum pump prior to securing the console Freeze Dryer to the floor. Roll the
console Freeze Dryer back into position and install the screws/anchors through the
holes in the cabinet floor and into the building floor.
FAILURE TO ATTACH THE CONSOLE FREEZE DRYER TO
THE FLOOR COULD RESULT IN ACCIDENTAL TIPPING
AND POSSIBLE INJURY 