Labconco FreeZone 4.5 Liter Freeze Dry Systems 77510 Series - Manual (Page 29)

Chapter 5: Maintaining Your Freeze Dryer
Product Service 1-800-522-7658 25
Monthly:
1.
The rubber components on the Freeze Dryer may eventually deteriorate and
require replacement. The effective life of rubber parts depends upon both their
usage and the surrounding environment. Check all rubber hoses and gaskets
and replace any that show signs of hardening, permanent set or deterioration.
2.
Using a soft cloth, sponge or chamois and a mild, non-abrasive soap or
detergent, clean the acrylic chamber lid.
3.
Using a soft cloth, sponge, or chamois and a mild, non-abrasive soap or
detergent, clean the exterior surfaces of the Freeze Dryer. Liquid spray
cleaners and polishes may be used on the exterior surfaces. Do not use
solvents to remove stains from the exterior surfaces as they may damage the
finish.
Annually:
1.
Every 12 months, or more often if the Freeze Dryer is operated in a dusty
environment, the refrigeration system condenser should be cleaned. Using a
vacuum cleaner with brush attachment, clean the condenser to ensure proper
airflow for peak performance.
Front Access Panel Removal
The front stainless steel panel on console models can be removed by placing a flat
blade screwdriver in the rectangular hole in the center of the kick panel. Pivot the
handle downward to disengage the latch and simultaneously pull the bottom edge
of the lower panel forward. The lower panel is installed by first sliding the top
edge under the lip on the plastic control panel. Pivot the bottom inward and push
until the latch is secure.