Laerdal AED Trainer 3 - Manual (Page 10)

10
SETUP
CHANGING THE CONFIGURATION
The AED Trainer 3 is shipped with a configuration replicating the default factory settings of the FR3 AED. If you want to
change the AED Trainer 3 configuration to match local protocols or for other training purposes, follow the steps below:
1 Squeeze the latch on the battery compartment lid to release the lid. Lift out the lid and set it aside.
2 Remove the Operating System Card from the slot at the top of the compartment.
3 Insert the Operating System Card into the card slot of your computer or, if no slot is available, install the card into a
standard card reader and connect it to your computer.
4 Open the AED Trainer 3 Configuration program (Aedt3Cfg.exe) and select the desired language for use during
configuration.
5 Click “Open,” and go to the drive with Operating System Card.
6 Click on “System” and then on “Config” and then open the “Config.Dat” file to load the existing Trainer 3 setup to the
program.
7 Adjust the parameter settings as desired in the program. See page 18 for detailed information about the available
settings.
8 After making all desired changes, click on “Update.”
9 Click “Exit” to close the configuration program.
10 Remove the Operating System Card from the computer or card reader and replace it in the AED Trainer 3. See
“Checking the Operating System Card”, for directions on installing the card. The AED Trainer 3 configuration will be
updated automatically the next time the AED Trainer 3 is turned on.