Laerdal AED Trainer 3 - Manual (Page 12)

12
SETUP
LAERDAL LINK TECHNOLOGY TRAINING PADS
To connect the Laerdal LINK Technology Training Pads to the AED Trainer 3, follow the steps below.
1 Remove the Laerdal LINK Technology Training Pads from their storagebag, leaving them on their liner.
2 Plug the pads connector into the pads connector socket on the front of the AED Trainer 3. Be sure the connector
clicks into place.
3 Place the AED Trainer 3 with the pre-connected pads in the carry case.The case is designed to store the AED Trainer 3
with the pads preconnected.