Laerdal AED Trainer 3 - Manual (Page 22)

22
REMOTE CONTROL
REMOTE CONTROL
A description of the button functions of the remote control is provided below.
Button Function
Scenario selection. Press to select one of the eight standard scenarios. (The AED Trainer 3 will
start the selected scenario.)
Pause/Resume. Press Pause to freeze all activity in the AED Trainer 3. (The AED Trainer 3’s On/
Off light will flash at a slow rate when the AED Trainer 3 is paused.) Press Resume to continue
the activity from the point at which it was paused.
Shockable Rhythm. Press to initiate simulated shockable rhythm.
(This function overrides the running scenario.)
Non-Shockable Rhythm. Press to initiate simulated non-shockable rhythm.
(This function overrides the running scenario.)
CPR First. Press to simulate a shockable rhythm that will generate CPR First decision by the
AED Trainer 3 for the first rhythm analysis, and a shock decision for subsequent rhythm analyses.
(This function overrides the running scenario.)
Good Pads Connection. Press to simulate good pads connection to the AED Trainer 3.
(This function overrides the detection of physical pad placement.)
Poor Pads Connection. Press to simulate poor pads connection to the AED Trainer 3.
(This function overrides the detection of physical pads connection.)
Motion Artifact. Press to simulate motion artifact interference with rhythm analysis. (This function
interrupts analysis and the AED Trainer 3 gives a voice prompt instructing the trainee to stop all
motion.)
Manikin Pads LEDs. Press to illuminate LEDs for pads placement on the manikin chest. (Applicable
only when using Laerdal LINK electrodes and a Laerdal LINK manikin.)
Error Condition. Press to simulate an AED error condition in the AED Trainer 3. (The AED
Trainer 3 turns off and chirps every 10 seconds.)
Note: To clear the error condition and turn on the AED Trainer 3 for further use, press the green
On/Off button twice.
AED Low Battery. Press once to simulate a Low Battery condition in the AED Trainer 3. Press a
second time to initiate a Replace Battery prompt.
Speaker Volume. Press buttons to adjust AED Trainer 3 speaker volume to any of three levels:
soft, medium, and high.
1 8
-
OK