Laerdal Virtual IV - Manual (Page 75)

8.1 Calibration of the Haptic Device
When the haptic device requires calibration, a message will appear on the screen which looks like this:
It is important to calibrate the device at regular intervals as prompted by the system, or the system
will “drift”, potentially causing erroneous measurements.
In cases where the haptic device is not connected or does not initialize properly, the following screen
will appear. Make sure that the device is properly connected. Once properly connected log off and
then back on, or simply go to the System Tutorial screen and return to the main menu. Exiting the
application and disconnecting and reconnecting the power cord to the device will usually fix this
problem. The initialization screen is shown below:
Administration
75 www.laerdal.com
Virtual I.V.
Directions for Use