Rocktron Utopia B100 - Manual (Page 60)

60
Step 6
Step 7
Turn the PARAMETER SELECT knob one step clockwise to display the Upper Limit
parameter (for PARA 1).
Step 8
Use the PARAMETER ADJUST knob to choose the highest value that the parameter
is not allowed to exceed when the toe of the expression pedal is down.
Step 9
ULIM C1 127
Step 10
Step 11
NOTE: Parameters available to be assigned may vary depending on what confi guration "CONFIG SELECT" you have
choosen for that particular preset.
Turn the PARAMETER SELECT knob one step clockwise to access the Lower Limit
parameter (for PARA 1).
NOTE: Because character space on the display is limited, you may not see the entire name of a parameter. For example,
to choose FLANGER LEVEL 1 or FLANGER PAN 1 (or any of the Flanger's parameters), select "LEVEL 1" or "PAN 1"
parameter that immediately follows the "FLANGER" parameter when turning the PARAMETER ADJUST knob clockwise.
This is true for some other parameters as well.
LLIM C1 50
LLIM C1 0
Use the PARAMETER ADJUST knob to select the lowest value which the parameter
is not to fall below through when the heel of the expression pedal is down.
ULIM C1 XXX
NOTE: The UTOPIA B100 allows you to select an upper and lower value limit which the parameter
cannot exceed. For example, if a parameter has a value range from 0 to 127, yet you would like the
range of the parameter to vary from only 50 to 127, you may set a lower limit of 50 and an upper limit
of 127 via the Upper (ULIM) and Lower Limit (LLIM) parameters. When a parameter is stored in the
Pedal Controller function (Step 7), the maximum parameter value is automatically stored as the upper
limit (expression pedal toe down), while the minimum value is stored as the lower limit (expression
pedal heel down).
To make changes to the second Pedal Controller turn the PARAMETER SELECT
knob clockwise one click.
NUMB 2 XXX
Repeat steps 3-10 to make changes to NUMB 2, PARA 2, ULIM C2, and LLIM C2
Selecting a lower limit value that is greater than the upper limit value will invert the response of
the controller - i.e. the toe position of the expression controller will provide the minimum value,
while the heel position will provide the maximum value.