Velodyne Digital Drive Series - Manual (Page 10)

www.velodyne.com 4 - Digital Drive Series User’s Manual
• PWR – causes woofer to stand by if in “Active” standby mode.
• NUMERIC kEyPAd – Used to enter SeTUP modeand for other
functions.
• SET (+/-) – Increases or decreases the Q valuefor a parametric
eQ, or sets values on the settings page.
• LIGHT – Turns the subwoofer’s front panel Velodyne logo
indicator on or off.
• NIGHT – limits the peak output of the subwoofer, and illuminates
the logo’s amber underlining to signify that the subwoofer is in
night mode.
• VOL (+/-) – Raises or lowers the volume of your subwoofer.
The blue (Velodyne) light flashes more quickly as the volume
increases, and the light blinksout the volume level after you stop
adjusting it. For example, for a volume of 34, you would see
three long blinks followed by four shorter ones.
• MUTE – mutes and unmutes the subwoofer.
• TEST – Used to toggle between the settings screen and the
system response screen during setup.
• EXIT – To exit SeTUP mode. The unit will ask if you want to save
settings before exiting.
• SELECT – To toggle field values.
• RESET – Used to reset volume to the last saved setting on the
main screen, and to defeat crossovers on the settings screen.
• MENU – enters SeTUP mode from the introductory screen.
• PRESETS – To access the five preset and one EQ defeat listening
modes. Initially set at the factory, they are fully user adjustable.
The blue (Velodyne) light flashes the appropriate number of
times to indicate which preset you have selected (e.g. twice for
preset 2).
nOTe: The button in the upper left is not used.
Figure 1: Velodyne Digital Drive remote control
REMOTE CONTROL BUTTONS
A brief description of each button on the remote control follows: