Velodyne Digital Drive Series - Manual (Page 39)

www.velodyne.com Digital Drive Series User’s Manual - 33
you can change any value in the presets column, then use the TeST key to review the curve with these settings
active. This is shown below.
Features of each preset are:
EQ. There can be a completely different set of EQs for each preset. Simply select the preset you want on
the “SySTem ReSPOnSe” screen where indicated.
Volume (+ or – from SyS). This setting deviates the preset’s volume from the established system volume
of the subwoofer. So, if you found during setup that 30 was a good setup volume for the subwoofer, then
if you increased the volume for preset one to 40, the 40 volume would be invoked when preset one were
selected for listening. If the system volume is changed (using the VOL + or VOL – keys on the remote), the
preset volume is adjusted in lock step with the system volume.
Crossover, subsonic filter, phase and polarity settings. normally these will not change from preset to
preset. However, it may be that you are using different satellites for different listening modes and wish to
set these settings individually for a specific preset. Note that the “setup” values cascade to the individual
values for the presets, but you can change all the individual values if desired.