Vortech 2011-2012 6.4L Hemi Challenger - Manual (Page 14)

P/N: 4CL020-020 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
4
4. COOLaNT & POWER STEERING RESERVOIR REPLaCEMENT
A. If there is still coolant present in the tank, remove
the coolant reservoir cap & drain the coolant from
the radiator drain port located on the bottom of
the radiator. For ease of installation, only drain
enough to empty the coolant reservoir. Once
drained, remove the factory-installed coolant
reseroir & install the supplied coolant reservoir
& refill. (See Fig. 4-a)
B. Remove the power steering fluid reservoir cap
& drain the power steering fluid by removing the
rubber line directly below the reservoir. Once
drained, remove the threaded line from the
power steering pump & set aside, then proceed
to remove the 3 screws securing the power
steering pump to the cylinder head. Additional
fittings will be installed in a later step. (See Fig.
4-b)
C. Locate the supplied power steering fluid reservoir
& install it onto the coolant reservoir as shown
in Fig. 4-a. Locate the rubber line previously
removed from the power steering reservoir &
install it onto the supplied power steering fluid
reservoir. Using the supplied large-diameter
power steering line, attach it to the bottom of
the supplied power steering fluid reservoir & set
aside. The other end of the large-diameter hose
will be installed in a later step. Secure both lines
with the supplied hose clamps. (See Fig. 4-c)
NOTE: For proper installation, the factory coolant reservoir &
power steering fluid reservoir will need to be replaced
with the included old-style reservoirs.
Fig. 4-b
P/S LINES
Fig. 4-a (Supplied Reservoirs)
COOLANT RESERVOIR
Fig. 4-c
SUPPLIED P/S
RESERVOIR
SUPPLIED
P/S LINE
FACTORY
P/S LINE
P/S FLUID RESERVOIR