Vortech 2011-2012 6.4L Hemi Challenger - Manual (Page 25)

P/N: 4CL020-020 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
15
10. CHaRGE aIR COOLER RaDIaTOR INSTaLLaTION
A. Attach the supplied brackets to each side of
the CAC radiator as shown in Figs. 10-a and
10-b. Remove the 8mm screws from the A/C
condenser & install the CAC radiator to the
condenser. Remove the two small plastic panels
from the front bumper cover as shown in Fig.
10-c.
B. Connect the water pump discharge to the bot-
tom hose barb on the CAC radiator using the
supplied 90º molded hose (and additional 3/4”
hose if needed). See Fig. 10-f (on the next page)
for CAC hose routing.
C. Attach two 90º molded hoses to the CAC core
& secure them with nylon ratchet clamps. Point
the two hoses towards the front of the vehicle.
(See Fig. 10-d)
D. Locate the 3/4” x 150º molded hose & attach
it to the upper hose barb on the CAC radiator.
Connect the other end of the 3/4” x 150º hose
to the 90º molded hose on the water inlet fit-
ting (upper fitting) on the CAC core using the
supplied hose menders & 3/4” hose (cut hose
to the appropriate length). Secure using nylon
ratchet clamps. Run the hose along the top of
the bumper beam. (See Fig. 10-e)
E. Using a hose mender, attach the 3/4” hose to
the remaining 90º molded hose on the CAC
core. Run the 3/4” hose parallel to the previ-
ously installed hose, routing the end of the hose
behind the drivers side headlight, up towards
the drivers side valve cover. Attach the other
end of the 3/4” hose to the upper fitting of the
previously installed surge tank & secure with
nylon ratchet clamps. Use zip ties to secure the
two hoses running along the top of the bumper
beam.
F. Remove cap from surge tank and slowly fill sys-
tem with 25%/75% coolant/water mix. Check
for leaks.
G. Re-install the front inner and outer fascias and
fender liner in reverse of removal.
Fig. 10-a
Fig. 10-b
Fig. 10-c
Fig. 10-d
Fig. 10-e