Vortech 2011-2012 6.4L Hemi Challenger User Manual
Page 15
P/N: 4CL020-020 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
5
5.
SUPERCHaRGER MOUNTING PLaTE INSTaLLaTION
A. There are (3) 10mm headed screws securing the
reservoir to the pump. (2) screws are located on
the back side of the power steering pump & (1) is
located on the pulley-side of the power steering
pump (not pictured). Remove these (3) screws,
then remove the power steering fluid reservoir
from the power steering pump. (See Fig. 5-a)
B. Carefully remove the o-ring from the previously
removed power steering fluid reservoir & transfer
it over to the supplied power steering adaptor
block. Be sure not to damage the o-ring. (See
Fig. 5-b)
C. Locate the supplied power steering fittings & clock
them as shown. Use a light amount of pipe seal-
ant on the threads. (See Fig. 5-c)
D. Locate the supplied mounting bracket assembly.
Loosely attach the steel bracket to the back of the
primary mounting plate. Attach the supercharger
mounting plate to the primary mounting plate using
the supplied M8x90mm bolts and spacers. (See
Fig. 5-d)
Fig. 5-b
P/S ADAPTOR
BLOCK
FACTORY O-RING
SUPPLIED FITTINGS
(ATTACHED IN A LATER STEP)
Fig. 5-c (Clocking Reference)
Fig. 5-a
RESERVOIR BRACKET
SCREWS
Fig. 5-d
SUPERCHARGER
MTG PLATE
PRIMARY MTG
PLATE
STEEL
BRACKET
P/S PUMP
P/S ADAPTOR
BLOCK ASSY.