Vortech 2011-2012 6.4L Hemi Challenger User Manual
Page 18
P/N: 4CL020-020 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
8
A. Install the supplied 3” aluminum idler using the
top most 3/8-16 hole on the mounting plate for
the idler pulley. Make sure that the snap ring
side is facing forward (away from the mounting
plate). (See Fig. 6-a).
B. Install the supplied power steering pump pulley
on the already installed hub using the supplied
1/4” hardware.
C. Install the supplied accessory drive belt as shown
in Fig. 6-b).
D. Position the supercharger in front of the mounting
plate assembly in front of the engine and install
and tighten the four 3/8” x 1 ¼” bolts.
E. Install the supplied cog belt around the pulleys
on the mounting plate assembly.
F. Using the supplied M12 x 100mm bolt, install
the supplied 3.5” aluminum idler with the bearing
retaining snap ring pointed towards the front of
the vehicle. The screw should pass through a flat
washer, S/C mounting plate, 1.55” idler spacer,
the idler, thick bearing washer, lock washer and
nut. Install the supplied nut and lock washer on
the end of the screw and tighten the idler so that
the gilmer belt is snug. (See Fig. 6-c).
G. Secure the remote drain hose away from the
belt and hoses using tie-wraps.
6.
SUPERCHaRGER INSTaLLaTION
Fig. 6-c
Fig. 6-a
Fig. 6-b
6.4L HEMI