Vortech 2011-2012 6.4L Hemi Challenger User Manual
Page 22
P/N: 4CL020-020 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
12
8.
CHaRGE aIR COOLER/DISCHaRGE aSSEMbLY INSTaLLaTION, CONT’D
H.
(See “Discharge Tube Identification” below).
Locate discharge tube B & install the supplied
silicone sleeve onto the shorter leg of the tube
with the 45º bends. Place hose clamps hand tight
onto the sleeve but do not tighten all the way.
I. On the shorter leg of discharge tube B, position the
hose clamps so they are pushed slightly towards
the back. This is in preparation for a later step.
(See Fig. 8-f)
J. Slide a silicone coupler onto the long leg of
discharge tube B, then slide the tube onto the
charge air cooler. Make sure discharge tube B is
resting on the discharge tube support bracket on
the passenger side. This will leave the other end
of the tube near the back of the engine, close to
the firewall.
K. Locate discharge tube C & install the factory IAT
sensor using the supplied rubber grommet. (See
Fig. 8-g)
L. Install the supplied 90 degree silicone elbow onto
the throttle body.
M. Locate discharge tube C & place the tube so that
the section with the two bends are near the back
of the engine, close to the firewall. Slide discharge
tube C into the silicone coupler previously installed
onto discharge tube B (See Fig. 8-h). Insert the
other end of discharge tube C into the 90º silicone
elbow previously installed on the throttle body.
N. Locate the supplied 1” silicone coupler & cut it so
it can be placed around discharge tube C. Place
the cut coupler around discharge tube C & posi-
tion it in a way to trap the drivers side discharge
tube support bracket between the coupler & dis-
charge tube C. Place supplied hose clamp over
the coupler. (See Fig. 8-i)
NOTE: As tube adjustment will be necessary, leave
all hose clamps loose until Step R.
Fig. 8-f (Tube B)
Fig. 8-g (Tube C)
Fig. 8-h
Fig. 8-i
Discharge Tube Identification
TUBE B
WIPER ARM
TUBE C
TUBE B
TUBE A
SUPPORT
BRACKET
1” COUPLER
TUBE C
IAT SENSOR
TUBE B
TUBE C