Vortech 2011-2012 6.4L Hemi Challenger - Manual (Page 5)

P/N: 4CL020-020 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
v
Before beginning this installation, please read through this entire instruction booklet and the Street
Supercharger System Owner’s Manual which includes the Automotive Limited Warranties Program
and the Warranty Registration form.
Vortech supercharger systems are performance improving devices. In most cases, increases in torque of
30-35% and horsepower of 35-45% can be expected with the boost levels specified by Vortech Engineering.
This product is intended for use on healthy, well maintained engines. Installation on a worn-out or damaged
engine is not recommended and may result in failure of the engine as well as the supercharger. Vortech
Engineering is not responsible for engine damage.
Installation on new vehicles will not harm or adversely affect the break-in period so long as factory break-in
procedures are followed.
For best performance and continued durability, please take note of the following key
points:
1. Use only premium grade fuel 91 octane or higher (R+M/2).
2. The engine must have stock compression ratio.
3. If the engine has been modified in any way, check with Vortech prior to using this product.
4. Always listen for any sign of detonation (pinging) and discontinue hard use (no boost) until problem
is resolved.
5. Before beginning installation, replace all spark plugs that are older than 1 year or 10,000 miles with
original heat range plugs as specified by the manufacturer and reset timing to factory specifications
(follow the procedures indicated within the factory repair manual and/or as indicated on the factory
underhood emissions tag). Do not use platinum spark plugs unless they are original equipment.
Change spark plugs every at least 15,000 miles and spark plug wires at least every 50,000 miles.
TOOL & SUPPLY REQUIREMENTS:
• Factory Repair Manual
• 3/8” Socket and Drive Set: SAE & Metric
• 1/2” Socket and Drive Set: SAE & Metric
• Adjustable Wrench
• Open End Wrenches: 3/8”, 7/16”, 1/2”, 9/16”
• Flat #2 Screwdriver
• Phillips #2 Screwdriver
• Drill Motor
• 1/8”, 3/16”, 1/4”, 27/64” Drill Bits
• 3/16” Allen Wrench
• Wire Strippers and Crimpers
• Utility Knife
• Thread-lock Compound (LOCTITE 242 or 248)
If your vehicle has in excess of 15,000 miles since its
last spark plug change, then you will also need:
• Spark Plug Socket
• NEW Spark Plugs
Dodge/Chrysler Hemi Cars
Installation Instructions
Congratulations on selecting the best performing and best backed automotive
supercharger available today... the VORTECH ® Supercharger!
®
ENGINEERING, INC.