Preparation and removal, cont’d – Vortech 2005-2009 Ford 4.6L 3V Mustang GT Air-Air Cooler User Manual
Page 10
P/N: 8N020-160
© 2008 Vortech Engineering
All Rights Reserved, Intl. Copr. Secured.
29DEC08v1.0(8N020-160v1.0)
2
Fig. 1-b
Fig. 1-c
8mm HeAded BoltS
CoolAnt
oVeRFloW HoSe
tWo uPPeR
RAdiAtoR HoSeS
HoSe to
tHeRMoStAt
I.
Locate the coolant drain plug on the pas-
senger side of the radiator. Next drain the
coolant into a clean container. This cool-
ant will be reused in a later step.
J.
Remove the two 8mm headed bolts
securing the coolant overflow reservoir to
the plastic fan shroud. (See Fig. 1-b.)
K.
Disconnect the small overflow hose (run-
ning across the top of the radiator) from
the overflow reservoir. (See Fig. 1-b.)
L.
Remove the large hose connecting the
thermostat hose to the bottom of the over-
flow reservoir. The hose and overflow res-
ervoir will not be reused. (See Fig. 1-c.)
1. PREPARATION AND REMOVAL, cont’d
NOTE: Retain only the fill cap for reuse..