Vortech 2005-2009 Ford 4.6L 3V Mustang GT Air-Air Cooler User Manual
Page 29
P/N: 8N020-160
© 2008 Vortech Engineering
All Rights Reserved, Intl. Copr. Secured.
29DEC08v1.0(8N020-160v1.0)
21
Fig. 3E-g | Passenger’s side
Fig. 3E-h
7.
Attach a 3" x 3" sleeve and #48 hose
clamps to the open end of tube “D”.
8.
Install the short end of tube “E” into the
sleeve attached to tube “D”. Secure the
tube support bracket using the previously
installed #48 hose clamp. (See Fig.
3E-g.)
9.
Attach the cast discharge duct to the
throttle body using the supplied 4.5"
sleeve and #72 hose clamps.
10. Using the remaining 3" x 3" bump sleeve
and #48 hose clamps, connect the long
end of tube “E” to the cast discharge
tube. (See Fig. 3E-h.)
11. Secure all hose connections at this time,
adjusting for best fit and clearance.
tuBe “e”
diSCHARGe duCt
TUBE
SUPPORT
BRACKET
SHORT END
OF TUBE “E”
3E. CHARGE AIR COOLER CORE INSTALLATION
(2007-2009 Models Only), cont’d
NOTE: For better fit, the transmission cooler lines
(if equipped) will need to be pushed
upward slightly so that tube “E” will fit
between them and the A/C compressor.
(See Fig. 3E-g.)