Vortech 2007-2009 FORD GT500 OEM POWER PACK UPGRADE - Manual (Page 19)

DP/N: 007125v1.0
© 2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
27AUG2010 GT500 OEM POWER PACK
14
5. POWER PACK CAI INSTALLATION, CONT'D
I. Assemble the carbon fiber intake tube with the
supplied hose couplers. Lubricate the inside of the
coupler on the filter side to aid in sliding over from
the intake tube and onto the MAF housing. This
coupler will need to be installed all the way onto
the carbon fiber intake tube until it is flush. (See
Figure 5-h)
K. Slide the intake tube coupler onto the throttle
body until it seats and tighten both hose clamps.
(See Figure 5-g)
L. With both clamps loose on the filter side, support
the filter with one hand and slide the coupler from
the intake tube over onto the MAF housing.
Re-aligning the housing and intake tube as you
slide the coupler will assist in engaging the cou-
pler to the housing. (See Figure 5-i).
M. Once the entire intake tube assembly is posi-
tioned properly (ensure the MAF is positioned out-
side heat shield as shown) and with adequate
clearance, then tighten all the hose clamps. (See
Figure 5-j)
N. Connect the MAF wiring harness.
O. Re-attach the breather hose.
P. Re-connect the bypass valve vacuum hose.
Fig. 5-g
Fig. 5-h
Fig. 5-i
NOTE: Using a light coat of clean engine oil will help
the couplers slide over the beads.
Fig. 5-j