Vortech 2007-2009 FORD GT500 OEM POWER PACK UPGRADE - Manual (Page 20)

DP/N: 007125v1.0
© 2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
27AUG2010 GT500 OEM POWER PACK
15
Fig. 6-a
SELECT
ARROW KEYS
IMPORTANT! To ensure trouble-free programming of your vehicle's computer:
• Make sure the vehicle's battery is sufficiently charged.
• Turn off all accessories and close doors to prevent unnecessary drain on the battery.
• Do not attempt to program your vehicle while a battery charger is connected.
• Improper battery voltage will result in failure of the programming process.
• Do not disconnect the cable or turn off the ignition during programming.
A. Reconnect the battery if previously dis-
connected.
B. Locate the vehicle’s OBD2 connector
located under the dash on the driver side
of the vehicle. (See Fig 6-b)
C. Attach the OBD2 connector from the
reflash tool that is provided in the kit to
the vehicle’s OBD2 port. Make sure this
connector is seated all the way in the
vehicle’s OBD2 port. Do not allow this
connector to become disconnected dur-
ing programming or damage may occur
to the vehicle’s ECM. (See Fig 6-c)
6. REFLASH COMPUTER
CANCEL
NOTE: • All vehicles equipped that have aftermarket ste-
reos will experience problems with the ability to
re-program the vehicle’s ECM. It is necessary to
disconnect the aftermarket stereo from the facto-
ry wiring harness before continuing with the pro-
gramming procedure.
• Do not disturb the cable or turn the ignition off
during this time. If the programming is disrupted,
the computer will not start or run your vehicle!
Fig 6-b
Fig 6-c
OBD-II
CONNECTOR