Datalogic Scanning DX6400 - Manual (Page 18)

COMMON FEATURES
16
Mechanical Installation:
The DX6400 reader can be positioned and installed in the best way possible as a result of the Step-A-Head
TM
feature. Thanks to the separation between Head and Base, you can modify the orientation of the decoder base,
and therefore display-keypad and connector panels, while keeping the optic head in the correct reading position.
The reading head and the decoder base can be rotated independently from each other allowing the installation
even in the most critical locations.
To rotate the head follow the given procedure:
1. detach the head from the base by unscrewing the four fixing screws;
2. rotate the head in the desired position;
3. loosen but don't remove the two screws on top of the head;
4. affix the head onto the base carefully aligning the four fixing screws and
progressively tightening them about half-way;
5. completely tighten the two screws on top of the head;
6. completely tighten the four fixing screws. Step- A-Head™ Feature
The following diagrams give the overall dimensions of the reader standard model, oscillating mirror model and
mounting bracket. They may be used for their installation:
85
[3.35]
60
[2
.3
6]
16.5
[0.65]
29
.9
[1
.1
8]
116
.8
[4
.6
0] 71.
8
[2
.8
3]
115.9
[4.56]
96
.9
[3
.8
2]
225.9
[8.89]
149
.8
[5
.90]
125.3
[4.93]
1
13.
1
[4
.45]
= =
= =
82 3.2
2
20 0.7
8
50
1.
9
6
18 0.7
1
N
°2
25
0.
98
10
0.4
22
0.86
42
1.65
Ø4
.1
N°
2
Ø0
.16
N°
2
4.5
N°
4 S
LO
TS
0.1
8 N
°4
SL
OT
S
82 3. 22
50 1.9
6
35 1. 37
50
1.96
72
2.83
100
3.93
4
0.15
13
0
5.
12 12
6
4.9
6
106°
73.2
2.88
36 1.
41
8.5 N°
2 SLO
TS
0.33
N°2 S
LOTS
Ш8
.5
Ш0
.33
mm
inch
DX6400 Overall Dimensions ST-237 Mounting Bracket Overall Dimensions
Head Screws
Fixing
Screw (4)