Lenco CR-2003 - Manual (Page 3)

Before using the CR-2003, the following requirements are
needed:
A broadband connection in combination with a
wired/wireless access point, router or similar network
device.
The network device needs to support WiFi (802.11b/g/n)
wireless connection.
A PC or smart phone with a network ready. This network
has to be the same one as the CR-2003 equipped with.
Do not drop the CR-2003 and do not expose it to liquid,
moisture or humidity. These might lead to damage to the
device.
If the CR-2003 is moved from a cold environment into a
warmer one, do let it adapt to the new temperature before
operate the device. Otherwise, it might lead to
condensation and cause malfunctions in the device.
Do not use the CR-2003 in the dust environment as dust
can damage the interior electronic components and lead
to malfunctions in the device.
Protect the CR-2003 from strong vibrations and place it
on stable surfaces.
Do not attempt to disassembly the CR-2003.
Only use the power adaptor delivered with the CR-2003.
The socket outlet should be installed near the CR-2003
and should be easily accessible.
Never touch the power adaptor with wet hands and never
pull on the power cable when pulling the plug out of the
power socket.
Make sure the electrical voltage specified on the CR-
1.1 Network Requirement
1.2 Safety Precautions
1. Before Started
3