Lenco CR-2003 - Manual (Page 31)

The first two alarms are similar to the normal alarm, turn on
then set the time and set it alarms Everyday, Once or every
specific day of week.
Select Alarm time. Set the respective values using / on
the remote control or the reel on the device and switch to the
next entry field using Confirm with OK or by pressing the
reel.
Choose Sound to set the sound to Beep, Melody or Radio
(Internet Radio or FM). An alarm symbol will appear on
the top of the display next to the time.
Note that the alarm source is from the preset Internet radio or
FM if Alarm Sound is set to be Radio. It can only set one same
IR/FM station for Alarm 1 and Alarm 2. When it reaches the
alarm time, the unit connects to the Internet if the set network
is available. Therefore there may be some delay from the
alarm to the radio play. If no network is connection in one
minute, the alarm will change to Melody automatically.
After NAP Alarm is set, it alarms once in 5/10/20/30/60/90/120
minutes depending on which one you have set.
You may choose Alarm Volume to configure the volume of the
alarms.
When the alarm(s) is/are set, there will be a clock icon at the
bottom of the display. The clock icon with alarm time will also
clearly display on the standby mode screen.
31