Avalon-mm translators, Transceiver dynamic reconfiguration – Altera SDI II MegaCore User Manual

Page 33

Advertising
background image

Avalon-MM Translators

The Avalon-MM Master Translator and Avalon-MM Slave Translator are Avalon-MM interface blocks

that access the Transceiver Reconfiguration Controller registers. The translators are not SDI-specific and

are automatically instantiated when the core interfaces with an Avalon-MM master or slave component.
If you want to bypass the Avalon MM translator in your design, connect

reconfig_mgmt_address[8:2]

from the reconfiguration management block to

reconfig_mgmt_address

from the Transceiver Reconfi‐

guration Controller.
You can connect the other signals from the reconfiguration management block directly to the Transceiver

Reconfiguration Controller.

reconfig_mgmt_waitrequest

reconfig_mgmt_read

reconfig_mgmt_readdata

reconfig_mgmt_write

reconfig_mgmt_writedata

For more information about the Avalon-MM Translator functions, refer to the Qsys Interconnect chapter

in volume 1 of the Quartus II Handbook.

Related Information

Qsys Interconnect

More information about the Avalon-MM Translator functions.

Avalon Interface Specifications

Transceiver Dynamic Reconfiguration

The dual and triple standard SDI receivers (or receivers of duplex SDIs) require the transceiver dynamic

reconfiguration feature to perform auto detection and locking to different SDI video rates. Transceiver

dynamic reconfiguration reconfigures the transceivers to support the three SDI video standards (SD, HD

and 3G).
Note: You need to perform transceiver dynamic reconfiguration on the SDI transmitter (or transmitters

of duplex SDIs) if you want to use the dynamic TX clock switching feature.

The dual and triple standard SDI use 11 times oversampling for receiving SD-SDI standard. As the rates

for 3G-SDI and SD-SDI are the same, transceiver reconfiguration is not required when the video standard

changes from 3G-SDI to SD-SDI and vice versa. Transceiver reconfiguration is only required when the

video standard changes from 3G-SDI or SD-SDI to HD-SDI, and vice versa.
To perform transceiver dynamic reconfiguration, you need the transceiver reconfiguration controller and

reconfiguration management/router blocks.

3-18

Avalon-MM Translators

UG-01125

2015.05.04

Altera Corporation

SDI II IP Core Getting Started

Send Feedback

Advertising