Altera Arria V Hard IP for PCI Express - Manual (Page 230)

17–8 Chapter 17: Testbench and Design Example
Chaining DMA Design Examples
Arria V Hard IP for PCI Express December 2013 Altera Corporation
User Guide
The following modules are provided in both Verilog HDL and VHDL, and reflect each
hierarchical level:
■ altpcierd_example_app_chaining —This top level module contains the logic
related to the Avalon-ST interfaces as well as the logic related to the sideband
bus. This module is fully register bounded and can be used as an incremental
re-compile partition in the Quartus II compilation flow.
■ altpcierd_cdma_ast_rx , altpcierd_cdma_ast_rx_64,
altpcierd_cdma_ast_rx_128 —These modules implement the Avalon-ST receive
port for the chaining DMA. The Avalon-ST receive port converts the Avalon-ST
interface of the IP core to the descriptor/data interface used by the chaining
DMA submodules. altpcierd_cdma_ast_rx is used with the descriptor/data IP
core (through the ICM). altpcierd_cdma_ast_rx_64 is used with the 64-bit
Avalon-ST IP core. altpcierd_cdma_ast_rx_128 is used with the 128-bit Avalon-
ST IP core.
■ altpcierd_cdma_ast_tx , altpcierd_cdma_ast_tx_64,
altpcierd_cdma_ast_tx_128 —These modules implement the Avalon-ST
transmit port for the chaining DMA. The Avalon-ST transmit port converts the
descriptor/data interface of the chaining DMA submodules to the Avalon-ST
interface of the IP core. altpcierd_cdma_ast_tx is used with the descriptor/data
IP core (through the ICM). altpcierd_cdma_ast_tx_64 is used with the 64-bit
Avalon-ST IP core. altpcierd_cdma_ast_tx_128 is used with the 128-bit Avalon-
ST IP core.
■ altpcierd_cdma_ast_msi —This module converts MSI requests from the
chaining DMA submodules into Avalon-ST streaming data.
■ alpcierd_cdma_app_icm —This module arbitrates PCI Express packets for the
modules altpcierd_dma_dt (read or write) and altpcierd_rc_slave.
alpcierd_cdma_app_icm
instantiates the Endpoint memory used for the DMA
read and write transfer.
■ altpcierd_compliance_test.v —This module provides the logic to perform CBB
via a push button.
■ altpcierd_rc_slave —This module provides the completer function for all
downstream accesses. It instantiates the altpcierd_rxtx_downstream_intf and
altpcierd_reg_access
modules. Downstream requests include programming of
chaining DMA control registers, reading of DMA status registers, and direct
read and write access to the Endpoint target memory, bypassing the DMA.
■ altpcierd_rx_tx_downstream_intf —This module processes all downstream
read and write requests and handles transmission of completions. Requests
addressed to BARs 0, 1, 4, and 5 access the chaining DMA target memory
space. Requests addressed to BARs 2 and 3 access the chaining DMA control
and status register space using the altpcierd_reg_access module.
■ altpcierd_reg_access —This module provides access to all of the chaining DMA
control and status registers (BAR 2 and 3 address space). It provides address
decoding for all requests and multiplexing for completion data. All registers
are 32-bits wide. Control and status registers include the control registers in the
altpcierd_dma_prg_reg
module, status registers in the
altpcierd_read_dma_requester and altpcierd_write_dma_requester modules,
as well as other miscellaneous status registers.