Subaru 2011 Impreza WRX - Manual (Page 128)

Black plate (130,1)
北米Model "A1110BE-C" EDITED: 2010/ 12/ 17
3-8
Instruments and controls
be displayed when the ignition switch is
in the
“ON” position.
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
The initial illumination setting of the
meter/gauge needles of your vehicle
has been set for activation
“ ” at the
time of shipment from the factory.
& Speedometer
The speedometer shows the vehicle
speed.
& Odometer/Trip meter
Turbo models
Non-turbo models
1)
Trip knob
This meter displays the odometer and two
trip meters when the ignition switch is in
the “LOCK”, “Acc” or “ON” position.
If you press the trip knob when the ignition
switch is in the
“LOCK” position, the
odometer/trip meter will light up. It is
possible to switch the indications while
the odometer/trip meter is lit up. If you do
not press the trip knob within 10 seconds
of illumination of the odometer/trip meter,
the odometer/trip meter will turn off.
The display can be switched as shown in
the following illustration by pressing the
trip knob.
* 1 : STI only
* 2 : “ ” or “ ”, and “ ” or “ ”
cannot be displayed when the ignition